Estimation of Drugs by Fluorimetric Technique

1. Aim

To complete the Year 3 syllabus practical estimation of drugs by fluorimetric technique using an instructor-approved method or dataset. Actual analyte, measurements, and result must be entered in the student record.

2. Requirements

Instructor-approved sample and reference standard, validated method, instrument and calibration records, blank and controls, observation sheet, calculator or graphing aid, protective equipment, and chemical waste route. Confirm sample identity from its label and use the college method sheet for reagent quantities, concentrations, wavelengths, pH, and temperature. Acceptance criteria are to be recorded from the assigned current monograph or approved college method in the student record.

3. Theory

Fluorimetry measures emitted light after excitation at a chosen wavelength. Signal can depend on concentration, solvent, pH, matrix, and instrument geometry; it may cease to be linear at high concentrations. A blank, standards, quality controls, and sample dilution record are needed for a valid estimate.

4. Procedure

Confirm sample identity, method version, hazards, instrument calibration, and required controls.
Record raw standards, blanks, sample readings, units, and any preparation or dilution factors.
Follow the verified laboratory method under instructor supervision, or analyze its supplied dataset.
Review excitation and emission settings, blank, standards, and sample readings. Fit the validated calibration range, interpolate the sample, and correct only with a documented dilution factor.
Check the fit, control recovery, and measurement range before applying a formula.
Report the calculation with units, method limitations, and unresolved details recorded in the student record.

5. Observation and calculation

Student record field	Entry
Case or product	Record here
Method	Record here
Observation	Record here
Inference	Record here
Supervisor check	Record here
Outcome	Record here

Assumed values for calculation practice only: Assumed calibration slope is 20 signal units per mg/L and assumed blank-corrected sample signal is 60 units. Assumed concentration = 60 / 20 = 3 mg/L before any dilution correction. These values are invented. Each invented input and output is assumed, not a reagent instruction or actual laboratory result.

6. Output or final result

Submit a labelled fluorescence calibration, calculations where justified, and a conditional conclusion. Record the supervised outcome here.

Teaching-lab safety: Use instructor-supervised chemical handling and the approved disposal method. No assumed value here authorizes a preparation or analytical release decision.

This page is a supervised-activity guide; it does not report a completed case.

7. Sources

← Potentiometric Titration of an Acid with a Strong BaseStudy of Quenching Effect in Fluorimetry →

Back to Pharmaceutical Analysis Practicals · All Pharm D Practicals · Pharm D

Theory notes: Pharmaceutical Analysis